News Letters

 Benefits

  • Removes grease, oil, carbon deposits, soil and grime.
  • Keeps loosened deposits in suspension preventing re.deposition.
  • Low toxic. ,Nonflammable,
  • Free from hydrocarbon solvents
  • Effective and economical in use, Water.based cleaner.
  • RXSOL-20-2028-210 has numerous cleaning applications including removal of greases, waxes, oil, sludge, soot, carbon deposits and general dirt and grime.
  • Non-corrosive to ferrous metals. Suitable for all tank•coatings.
  • Can be used for gas and hydrocarbon freeing of tanks.
  • Can be used for deodorizing
  • Contains wetting agents.
  • Acts as an acid.neutralizing agent also.

 

It is free from hydrocarbon solvents, Biodegradable minimizes the extreme hazards to personnel in handling materials.Suitable for cleaning of Lube oils Gas oil Kerosene Mineral oil Products. Phosphates paraffin's vegetable oils Dour intensive products. 

Tech Spec


Using-Procedure: 

First of all flush the system with cold water to prevent evaporation rates and polymerization then the most economical method of using RXSOL-20-2028 is by direct injection followed by recirculation washing, using tank cleaning machines.


Spraying Method: 

Using CTC as delivered in drums, spray onto areas where residue remains following rough washing leave for 10-45 minutes (but do not allow to dry), then butter-worth at maximum pressure and warm water 60oC for at least 3 hours, checking that there is no foam remaining in the final stages. Incorporate rectangle nri if Orinoco rps It ha< [-loon precarious fresh water rinse and dry.

.


"Make sure to take all safety precautions are followed when handling/spraying CTC."

Injection Method:-
I lot applicable.


Re- Circulation Method:-

  • Fill tank with fresh water and heat up to warm 50°C . IF a drop line is available on the tank line system, then start to circulate the water and add the required amount of Caustic flakes and CTC to make a 2.5% solution. A stronger solution can be made, but be advised that too much Caustic and too high temperature will result in white powder all over the tank. Under normal circumstances, between 2.5% and 4.5% will be sufficient strength. If there is no drop line, then lower butter worth hoses into the tank from the pump stack header without machines attached and circulate through these hoses while you fill the solution material.


"Use a strainer at the pump stack when circulating any solution." Tank Lining— Stainless / Epoxy/ Phenolic, "

Dose: 

Necessary concentration in water only 0,2 to 0,4 %

 

 

Contact : 123@rxmarine.com